It's Been A Little While Sorry! Here's a Scarf Tute

Hello there!
Firstly I have to apologise as it's been a good few months since my last post- awful blogging etiquette I know, I'm very sorry. I will mend my ways, promise!

I have still been making things including the following scarf! It was made by recycling a pair of palazzo trousers. I took pics along the way, albeit rubbish ones with my phone but you can get the idea from them.

First you need a pair of trousers with baggy legs (although you could skip this step if you have fabric you like, or use a long skirt/dress- whatever you like). I loved these trousers but with a hole by the zip and the bottoms getting a little worn it was time to re-purpose them. The trousers (or the fabric) will need a good iron.

From each leg cut two equal rectangles of fabric so you have four pieces of fabric all the same size, in my example the sections measured roughly 26cm x 76cm (11 x 30 inches).

With right sides together,  sew two of the section together along the shorter ends. Repeat the same step with the other two sections (my fabric looks very similar on both sides in the photographs but the birds on the outside are more crisp in colour). 
I used a 1cm seam allowance throughout the project (except for the final seam).

Open both sections out so you have two double length pieces, each with a seam in the centre. Pin these two lengths together, again right sides together, with the seams meeting in the centre. Sew the two long sides together.

At this stage you will have a long tube with the seams on the outside. Tuck one half inside the other with the right sides together so that the unsewn edges meet (with the sewn seams meeting on either side). Pin these together and sew around the edge leaving a section open.

The section left unsewn- approximately 10cm.

Turn the scarf the right way out through the unsewn hole, so all the seams are on the inside.
Tuck the raw edges in and the pin the hole closed.

As close to the edge as possible sew the opening closed.

The finished seam...

And that's the scarf done!

All ready to wear- just wrap it around twice and you're all set.

Here's a picture of the finished scarf (after a day's wear) to show it's length open- approx 66cm (26in) or about the length as a semi stretched cat, who was keen to help with my measuring ;-)

I'm very pleased with how it turned out as I really love the fabric and still get to enjoy wearing it, even though the trousers were past their best.
I'm definitely going to make more using raw fabric (rather than altering items of clothing) for Christmas presents for friends.
Thanks for taking the time to read this post! 
Until next time (which I promise won't be as long as last time), craft in earnest! Craftin' Ernest x

Storage Solution- Upcycled Box

Something my husband and I disagree upon quite regularly is how much stuff in the house is too much stuff? 
He strongly believes we passed the acceptable mark a long time ago and I've told him this is one of the downfalls of living with a "crafter"- to me there is no such thing as too much! 
OK I wouldn't like to end up on one of those reality TV shows where the council is sent in because you haven't thrown anything away for 20 years and can't move for old newspapers and dirty dishes with new lifeforms growing on them. 
But too much wool- not possible, overload of fabric- I don't think so, button boxes bursting at the seams- my idea of Heaven!
You just know the day you get rid of something is the day you find that's exactly what you need, that's a real frustration I do my best to avoid.

I will concede that this does make storage a bit of an issue and as such I do have a lot boxes, baskets, tins, pots, etc. 
I enjoy filling them with bits and bobs, forgetting where everything is and then rooting through them all making lots of discoveries, getting distracted and going off on a complete tangent.

I have boxes of all shapes and sizes, many of which people have kindly donated to me.
If I get a chance to decorate them before I fill them to the brim (this is rarely the case) so much the better.
My sister recently gave a box she had received as a gift from a friend at Christmas full of lovely Body Shop goodies.

It was a nice sturdy box just right for a make over, so using some gorgeously ornate, eco-friendly wrapping paper from Wild & Wolf Ltd along with some Sugru, mouldable silicone glue, I transformed it into a vintage-style suitcase.

I cut one of the edges of the lid into a flap before covering the outside with the wrapping paper. I moulded the Sugru over the corners and used it to make attachments for the handle.

Once the Sugru parts had cured I painted them with gold coloured enamel paint. I made the handle using leather (also painted gold) and I attached it with wire rectangles made from hair pins. I added some decorative trim and flat metal beads as fake closures and the job was done.

Of course, now I have to find it a permanent home without upsetting the hubby....
I'd love to know what you think of the finished case and whether you believe there is such a thing as too much crafting stuff (although I'm going to stick with no)?

Until next time craft in earnest, Craftin' Ernest x

Wrapping Paper

I love wrapping presents, so much so I'd do it as a job if I could.
Having said that I can feel rather guilty about the frivolous nature of wrapping gifts with paper and the cost to the planet. I always try to unwrap things carefully so I can reuse the paper for something, be it to wrap something else or to make a card or line something, whatever it is it's good to reuse and is cost-effective too- a nice bonus! There are some really gorgeous papers out there that are such good quality they can be used over and over, especially if tied with ribbon instead of using sticky tape.

I'm always on the look out for for things to use as wrapping paper or to make gifts bags etc.
With this philosophy in mind I rescued some paper from work recently after the photocopier had a "software malfunction" and printed out a document as a series of lines similar to a barcode. Most had an overall green appearance due to the stripes being blue, yellow and black and some were just black and white.

I immediately thought the green tone paper would make great Christmas wrapping and the black and white could be easily jazzed up.

I made a gift bag using one sheet of the green, just the right size to pop a few small Christmas presents before finishing it off with a festive bow. I used a box of tea as the base structure (see below) and began wrapping as per normal at one end but without sticking anything down. I then drew a flap template at the other end which I cut out with scissors. I stuck the edge and the folded end together with double sided sticky tape and attached a strip along the edge of the flap, ready for sealing.

Using this wonderful origami tutorial from the delightful Gathering Beauty, I used two, green sheets to make a box. I finished it off with red and white striped washi tape along with a gift bow made with the same tape and plain paper off-cuts. It's just right for a Christmas present of jewellery. 

I used a pink and a yellow highlighter to spruce up a sheet of black and white, I thought this was "bang on trend" ;-) as neon is everywhere at the moment and would be good for my friend's birthday as she likes bright colours. It looks great with black ribbon

Making your own stamps as in this post is a great way to personalise plain paper into something a little more special and could even make newspaper a possible source?!
The other black and white sheet was calling out for haphazardly stamped, hot pink bumblebees and to be made into a gift bag.

I covered it with transparent, sticky vinyl then I used the same technique as the Christmas bag, although, this time, I stuck the edge and flaps down as I went.

I then folded the top 2cm down all the way around and cut 2 holes in both of the wide sides approximately 1cm down. I threaded a piece of ribbon (liberated from inside a cardigan) through each side to create handles and used a bead on each end before knotting for extra security. I also popped a rectangle of card in the bottom for a bit of extra strength.

When that's all done you're left with with a lovely little gift which is durable enough to be used over and over!

I hope you like the results? Thanks so much for visiting my blog.

Until next time- craft in earnest, Craftin' Ernest x

Statement Kumihimo Necklace

Have you ever liked something so much you decided to make it in every colour? That's what's happened with this necklace.

I bought a jazzy, beaded belt from a charity shop for the beads as it was completely chocked full of them. As a belt it wasn't to my taste but I decided to take it apart and make something new and that led to the first necklace. Then it was a case of making one in each of the colours ;-)

As I have mentioned before, I really enjoy Kumihimo weaving, the basic method is quite simple to pick up and once you've got it it's very quick and a little bit addictive. That's before you even start to use beads, then it takes on a whole new dimension. I have a foam Kumihimo "loom" from Beadsmith and it's brilliant. They're quite cheap, less than £4 (UK) and can be used with everything from nylon thread to chunky wool! They come with instructions and you can also buy kits that include the materials to make your first project.

I have seen people make they're own using cardboard but I think the foam one helps as it holds the strands well.

Here's great link to a video direct from Beadsmith on YouTube which is fantastic if you're new to using beads with Kumihimo - http://www.youtube.com/watch?v=utQVPP7ky2g 

It's how I learnt to add beads and explains the technique perfectly! I also have the Beadsmith bobbins as seen hanging down from each thread in the photo below but prior to owning them I just used cardboard bobbins such as used with cross-stitch cotton.

Make a length of beaded Kumihimo weaving approximately 12cm (5") in length.

Wrap your chosen coloured wire around something of a suitable diameter. For example I use knitting needles as I have a lot of them to hand and I can use whichever diameter I think best suits each particular necklace. The picture below is a 5mm needle which is my standard go-to size. You can wrap it as tightly as you like. Sometimes I do it pretty tight but a little loose as in this example looks good too.
Wrap it until you have a coil approximately 3cm (1") long

Thread 3 beads and your wire coil onto a length of wire and create a loop at the end. Hook this onto the end of your beaded Kumihimo. (From the second necklace onwards I actually put a jump ring on the end of the beaded section before I started and one after I finished weaving to make things easier. If you do this hook the length of wire to the jump ring.) Then create a loop at the opposite end, where the beads are, and cut the excess off. Secure the end of the loop inside the last bead.

Thread a length of chain through the loop to create a double layer of chain.

Attach a jump ring the both ends of the chain.

Attach an extension chain to one side and a lobster clasp to the other side.

That's it ready to wear!
As I said I have made it in lots of colours thanks to the belt and a few more with other slight alterations :

I hope you like them too!
Craft in earnest, Craftin' Ernest x